PDA

View Full Version : What does this message mean?




Falleron
Dec 10, 2002, 06:51 AM
Actually, its quite an obvious message. see below:

- para+ Network send failure
- Error: Could not transmit unit 02. Keeping unit in queue.

However, I have been trying to send this unit back all day + cant seem to do it! The problem is that if I dont send it back soon I will go past the deadline. What should I do? Is there anything I can do?

Thanks



BenderBot1138
Dec 10, 2002, 07:15 AM
I much prefer this error message ...
NOT posted by Ellen Fleiss
... it was like beep beep beep beep ...
Get a C3PO model and get it to tell the 02 Unit to get back in the queue...

:cool:
__________________________
IM NUMBER 128! IM NUMBER 128!

Over Achiever
Dec 10, 2002, 07:59 AM
That usually happens when a server goes down...I had that happen to me once. Don't worry about the deadline...I know I missed the deadline once, but the unit was still sent.

The unit will be sent when your current unit is sent...you'll just send two units instead of the normal one.

Don't worry too much about it.

Falleron
Dec 10, 2002, 08:13 AM
Thanks. The original unit was 9 points + the one I am doing now is a 6.4 point unit. Could take a while until this new unit is completed.

bousozoku
Dec 10, 2002, 04:07 PM
In this case, the server (.119) is not just down but was removed entirely from the status list. I'd like to send off the three work units I have ready, but no such luck.

I noticed that the server was overloaded--over 100 connections at any given moment--when I first had trouble and there seemed to be many every time I checked as if the server was being attacked.

bousozoku
Dec 10, 2002, 06:14 PM
That server is going again. :)

Falleron
Dec 11, 2002, 05:54 AM
Just sent it back :-) .