PDA

View Full Version : problems with a g3 powermac




excalibur313
Dec 4, 2006, 02:22 PM
Hey Everyone,
This is going to date you all a lot but I have a powermac g3 (640mb ram, 300mhz) with a 15" apple crt monitor. I moved it into a new room and all of a sudden the display is virbrating slightly. If i switch the refresh rate back to 60 it goes away but then that looks so bad that I have to bump it back up to 70hz. Is there any settings that I can change to fix this vibrating? Like I said, this didn't happen until i moved the computer 20 feet into a neighboring room.
Thanks!
Stephen



Sun Baked
Dec 4, 2006, 02:26 PM
Near a tv, speaker, etc.

Or is there a fan, blower, stand also air cond. or heater, flourescent light, on the same circuit as the computer. Does not have to be in the same room, but share the same circuit breaker as the machine.

My guess would be a fan or fluorescent light -- motors and ballasts tend to toss out some electronic noise.

excalibur313
Dec 4, 2006, 02:31 PM
Wow! You are good. I had a transformer for the speakers that was right near the monitor. As soon as I plugged it in far away it worked perfectly. Thanks!