robotjustin
Oct 24, 2003, 01:35 PM
Hi
I have an older ADS raid box, the API-910.
It has two hot swappable trays for hard drives.
I recently replaced the board in the back (two rows of FW 400 ports linked by a small 6pin to 6pin FW cable) with a firewire 800 board I bought from cooldrives.
Chaos ensued.
I had two WD 120 drives in the two trays, which were both 1/2 paritioned. I lost the paritions, and went through hell recovering the data.
FInally, I got it all back, reformatted the drives, and here's the problem:
I can only get ONE drive to read at a time. I tried it on two computers (a G5 1.6 and an older G4 450DP) and same thing. So I swapped the FW800 card back with the old FW400 and it's the same issue, only one tray at a time will read.
Please advise.
(I ran disk utility, repaired permissions, ran the HARDWARE UTILITY on the Jaguar disk. Everything comes up OK.)
THANKS!
I have an older ADS raid box, the API-910.
It has two hot swappable trays for hard drives.
I recently replaced the board in the back (two rows of FW 400 ports linked by a small 6pin to 6pin FW cable) with a firewire 800 board I bought from cooldrives.
Chaos ensued.
I had two WD 120 drives in the two trays, which were both 1/2 paritioned. I lost the paritions, and went through hell recovering the data.
FInally, I got it all back, reformatted the drives, and here's the problem:
I can only get ONE drive to read at a time. I tried it on two computers (a G5 1.6 and an older G4 450DP) and same thing. So I swapped the FW800 card back with the old FW400 and it's the same issue, only one tray at a time will read.
Please advise.
(I ran disk utility, repaired permissions, ran the HARDWARE UTILITY on the Jaguar disk. Everything comes up OK.)
THANKS!
