Ok, here is the setup:
I have a linksys BEFW11S4 with the wireless signal disabled. Plugged into the 4 port switch on the BEFW11S4 I have connected a WAP11 (v.2.2). All of my wireless computers can connect to this signal fine (get on internet etc). However, I need to extend the signal further. I have another WAP11 (v.2.6) which I have upgraded so that I can get the repeater function.
My problem is that when connected to this repeater I dont get the internet etc. Its acting on its own.
Each Access Point has its own IP address. Both Access points are working - can connect to either. MAC address of first access point has been inputted into second access point.
Any ideas of how you setup this repeater function??
Appreciate any ideas.
Thanks
I have a linksys BEFW11S4 with the wireless signal disabled. Plugged into the 4 port switch on the BEFW11S4 I have connected a WAP11 (v.2.2). All of my wireless computers can connect to this signal fine (get on internet etc). However, I need to extend the signal further. I have another WAP11 (v.2.6) which I have upgraded so that I can get the repeater function.
My problem is that when connected to this repeater I dont get the internet etc. Its acting on its own.
Each Access Point has its own IP address. Both Access points are working - can connect to either. MAC address of first access point has been inputted into second access point.
Any ideas of how you setup this repeater function??
Appreciate any ideas.
Thanks