PieMac
Oct 29, 2002, 08:55 PM
Hello all,
In short, I had to take out my keyboard earlier this eve and the locking screw in the top center of the board came out as I was trying to unscrew it. Go figure as I have taken my keyboard out a couple of times before with no problems. I'm not sure what caused it to do this as I am always super careful with it...it just didn't tighten down like usual so I went to unscrew it to try again and *pop*...out it came.
I'm having a heck of a time getting it to go back in flush like it was....there's an oblong lip on the backside of the screw that fits in just so but I can't seem to get it quite there and I am scared to apply any force. Anybody here ever had this happen? Any help would be greatly appreciated!
In short, I had to take out my keyboard earlier this eve and the locking screw in the top center of the board came out as I was trying to unscrew it. Go figure as I have taken my keyboard out a couple of times before with no problems. I'm not sure what caused it to do this as I am always super careful with it...it just didn't tighten down like usual so I went to unscrew it to try again and *pop*...out it came.
I'm having a heck of a time getting it to go back in flush like it was....there's an oblong lip on the backside of the screw that fits in just so but I can't seem to get it quite there and I am scared to apply any force. Anybody here ever had this happen? Any help would be greatly appreciated!
