Changing the input language in classic

[gdavid]

I have a few science drawing and search programs that have to run in classic, which is fine. Except I am used to touch typing in the dvorak layout, which I have it set on normally, and every time I open up one of my classic programs the layout changes back to qwerty and I can't figure out how to make it use the dvorak layout. Does anyone know how to do this? Thanks.

[MisterMe]

I have a few science drawing and search programs that have to run in classic, which is fine. Except I am used to touch typing in the dvorak layout, which I have it set on normally, and every time I open up one of my classic programs the layout changes back to qwerty and I can't figure out how to make it use the dvorak layout. Does anyone know how to do this? Thanks.Use the Keyboard Control Panel under Classic. From there, you can set your keyboard to Dvorak layout.

[gdavid]

Use the Keyboard Control Panel under Classic. From there, you can set your keyboard to Dvorak layout.

That was so simple to do but I just hadn't found the place to do it, thanks.