white unibody bottom isnt flush where it meets up

[dukebound85]

with the plastic all the way around. the upper left corner leaves the plastic/rubber interface slightly rough in the sense the plastic is overhanging just a tad for example. is this normal? its not way off but some areas around perimeter are uber flush..... or am i being a bit too anal?

[dukebound85]

this common? or should I just not care

i hate having new things!

[sml238]

idk mines pretty even all the way around but i wouldnt worry about it. its not a big deal...i feel like the problem with us being on this forum is we care about our macs way to much lol. when i used to use pc and not be on any forums i just used my comp and didnt really care as long as it worked..

i try to still keep that mentality when i worry too much, but at the same time take care of my mac and know about it as much as i can.

[macgeek18]

with the plastic all the way around. the upper left corner leaves the plastic/rubber interface slightly rough in the sense the plastic is overhanging just a tad for example. is this normal? its not way off but some areas around perimeter are uber flush..... or am i being a bit too anal?

I have the same problem,my bottom plate isn't even with the unibody shell,it looks like the screws aren't tight enough but there all the way in.

[blackburn]

yep we worry about our mac's too much when I had my hp I didn't care about it. But that happens with my macbook too, in some places uber flush, and others not that flush:p

[sml238]

oh also try loosening your screws a tad and pushing the bottom plate the way it needs to go. when i put my new hard drive in i found myself doing this to make it flush.