Got a tip for us?
Let us know
Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.
Disabling 3G resolves the signal issue
- Thread starter nooaah
- Start date
- Sort by reaction score
lol...
but it also implies it's quite possibly a firmware/software issue or even a frequency issue, do 3g and 2g operate on the same bandwidth?
quagmire
macrumors 604
Yep with the exception of 2100 Mhz and 1800 Mhz.
UMTS/HSDPA/HSUPA (850, 900, 1900, 2100 MHz)
GSM/EDGE (850, 900, 1800, 1900 MHz)
hmmm I'm wondering if the issue is specific to areas where they are using a certain frequency, as i believe higher frequencies are more affected by antenna size.
Either way, I see no hardware reason why Edge would be immune to something that affects 3g.
quagmire
macrumors 604
What I am thinking is that as stated by Apple, the phone picks the best signal for quality. So when you put your finger over the antenna( I am sure some of the signal gets absorbed by the finger), the phone thinks the quality of the signal is poor so it switches to another frequency which doesn't have the best signal in your area. I am betting the software is too sensitive or the phone is too quick in switching frequencies.
Either that or it's messing with signal gain settings and it screwing itself up. Either way, if 2g works just fine and 3g is having issues operating on the same spectrum, it pretty much MUST be software/firmware
frozencarbonite
macrumors 6502
This is very hopeful. I'm really hoping it's a software issue. This will be my wife's first iPhone and first time with AT&T. I really hate for her to get a bad phone and then be stuck with AT&T for 2 years. She would not be happy at all.
I tried disabling 3G and covered the same spot on the phone and I go from 5 bars to 2 bars. With 3G I go from 5 bars to 1 bar. This is at home where I have a strong signal.
Might be a signal issue since we have the issue at home but my wife is in another area and is not dropping bars holding the phone bridging the top and bottom of the left side.
I do tech support for samsung, and you sound like the idiots who call in because they aren't getting a picture on their tv, and refuse to try and connect the yellow rca cable in addition to their hdmi cable to TEST the connection because they don't want to use the "out dated" cable.
I really doubt this was intended as a solution, it's troubleshooting to determine the cause of the issue.
If what the OP stated were true, that 2g works fine and 3g has issues using the same spectrum and antenna, it would imply it's either a different hardware issue, or a software issue. Do you really not see how that MIGHT be relevant?
Whoa, that's creepy, how'd you know I was a bro:
lol'd at photoshopped tattoos and piercings. that was pretty funny.
Kadman
macrumors 65816
I think those seeing the improvement when disabling 3G are just in locations where the 3G signal/tower is different from the 2G. In other words, they're far enough away from the 3G tower that covering them as outlined kills enough of an already "lesser" signal down. However, the 2G signal is still strong enough to maintain decent contact. Just a theory.
Also, if it's literally contact that's causing the issue (i.e. conductivity) then wouldn't a possible band-aid be to cover them with clear film, similar to some of the kits that people buy to protect from scratches? Hell, you could test the theory with pieces of cellophane tape. lol
Also, if it's literally contact that's causing the issue (i.e. conductivity) then wouldn't a possible band-aid be to cover them with clear film, similar to some of the kits that people buy to protect from scratches? Hell, you could test the theory with pieces of cellophane tape. lol
This could be true.
My 3G signal, unobscured right now, is a somewhat crappy -87dB (-113dB with hand over antenna).
The Edge signal is a somewhat better -71db with no change to signal strength regardless of hand position.
quagmire
macrumors 604