Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.

DDemon666

macrumors newbie
Original poster
May 6, 2012
5
0
It was working today, I had an issue with the camera so I made a custom no baseband firmware with Sn0wbreeze and restored it (same 4.3.3 firmware), installed Ultrasn0w, the carrier and bars aren't showing anymore, one bar only is showing and I can't call.
Help please.:confused:
 
It was working today, I had an issue with the camera so I made a custom no baseband firmware with Sn0wbreeze and restored it (same 4.3.3 firmware), installed Ultrasn0w, the carrier and bars aren't showing anymore, one bar only is showing and I can't call.
Help please.:confused:

That is a cosmetic bug - 1 signal bar - caused by firmware/baseband mismatch
Ultrasn0w will correct it plus unlock that baseband.
Did you correctly install Ultrasn0w.
When the Respring button appears, turn the phone off instead, then back on.
One additional reboot might be required.
 
Check to see what is your baseband version in settings/general/about.

It's 1.59.00.

----------

That is a cosmetic bug - 1 signal bar - caused by firmware/baseband mismatch
Ultrasn0w will correct it plus unlock that baseband.
Did you correctly install Ultrasn0w.
When the Respring button appears, turn the phone off instead, then back on.
One additional reboot might be required.

Rebooted a hundred times, same problem.
If it's a "cosmetic bug" why can't I call?
 
Any alternative solution? I don't have iOS 5.0.1 SHSH and I want to keep it untethered. Any help is appreciated.
 
Last edited:
Did you eject sim and reinsert?

Which ultrasn0w version are you using?

Try making a custom NO_BB firmware with redsn0w, it's better than snowbreeze.
 
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.