|Feb 9, 2013, 05:30 PM||#1|
Going to upgrade my Mac Pro, need advice!
So I have a Mac Pro that I mainly use for Adobe After Effects (CS 6) and Ableton 8 and would like to make some performance upgrades to optimize those two applications.
Here's an overview of my current setup:
Model Name: Mac Pro
Processor Name: Quad-Core Intel Xeon
Processor Speed: 2.8 GHz
Number Of Processors: 2
Total Number Of Cores: 8
L2 Cache (per processor): 12 MB
Memory: 2 GB 800 MHz DDR2 F8-DIMM
Bus Speed: 1.6 GHz
I would like to get the most of my computer and am not too worried about cost. Don't wanna cheap out on anything. So if anyone has any recommendations on what I should buy to really speed things up on my system I would really appreciate the help!
|Feb 9, 2013, 09:48 PM||#2|
Memory, memory, memory. AE needs more memory. 8GB min. Better at 16GB+. SSD next on list for boot and apps and maybe a new 1TB single platter Seagate HDD that can push 200MB/s+ for streams.
Mac Pro W3680, GTX 680, 12GB DDR3, SSD; MBP, 2.6GHz Core i7, 16GB DDR3, SSD; Eizo fs2333
|Feb 10, 2013, 06:54 AM||#3|
Assuming this is a MacPro3,1 (early-2008) - sounds like it in your description - you have two challenges; RAM is expensive, and you are using an older version of SATA (ver. 2.0).
But, You have to little RAM, get 16GB (at least). It is indeed expensive, but if you want to save a little, you can use the slightly slower 667MHz DIMMs.
However, to take full advantage of todays faster interface, you might consider getting a PCI SATA card, for your SSD. These allow you run HW RAID as well, and your system will really shine. There are also a few cards with tons of RAM on them, acting as an SSD, the Accelsior from OWC for instance...
Lastly you can always put a fast CUDA graphics card in your MP. The GTX570 is great for CS applications.
nMP 3.5GHz 6C/64GB/1TB/2xD700 - Echo Express 1TB Accelsior/2x500GB Sonnet Tempo Pro - MBP 15"/2.53GHz/8GB/250GB SSD - MBA 2GHz i7/8GB/250GB - MMI 2.3HGz/8GB/500GB - TC 3TB - ReadyNAS Pro 6x3TB
|Feb 10, 2013, 09:11 AM||#4|
If it is a 2008 Mac Pro 3,1 like mine then there are a few upgrades that are really worthwhile. The RAM as others have said. It's expensive but worth it. Secondly an SSD. If you just put this in one of the regular drive sleds the SATA-II bus will throttle it but it will still be 2X faster than a rotating hard disk. It is however much better if you have a free PCI slot to get an Apricom Velocity X2 & mount the SSD on that for full SATA-III performance. Finally a good CUDA graphics card like the GTX570 (available used on eBay for under $200 or equivalent) will enormously improve the performance of some but not all After Effects rendering
|Feb 11, 2013, 05:41 PM||#5|
If cost is not a problem, why not sell that one and get at least a 2009, but recommend a 2010. The westmere processors are more efficient, the memory is cheaper and faster. I had a 2008 mac pro like yours. I enjoyed using it to edit video. Maxed my memory out but jeez, those fsb memory modules are expensive. Still think the 2008 mac pro was the best bang for your buck of mac pro's. Miss the platform but not the cost of the newer ones. Reason why I built my dual xeon pc. Think you would be better served with a newer model. But if your set to stay with the 2008, put as much memory as you can afford and get an ssd.
2010 2.66 Mac Mini, 2 ATV, iPhone 4S, Dual X5670 2.93 Westmere Win7 PC w/48gb ram & 4930K w/32gb ram Win7.
|Feb 12, 2013, 01:21 AM||#7|
From Apple's link:
"Mac Pro (Early 2008)
The Mac Pro (Early 2008) computers implement PCI Express revision 2.0 which support twice the data rate per lane as the PCI Express revision 1. Slots 1 and 2 are both x16 revision 2.0 slots. Slots 3 and 4 are both x4 revision 1 slots. Placing a revision 1 card in a revision 2.0 slot, or visa-versa, is supported and results in a revision 1 link.
The number of lanes for each of these slots is permanently set for the Mac Pro (Early 2008). The Expansion Slot Utility doesn't apply.
Mac Pro (Early 2009), Mac Pro (Mid 2010), and Mac Pro (Mid 2012)
The Mac Pro (Early 2009), Mac Pro (Mid 2010), and Mac Pro (Mid 2012) computers implement PCI Express revision 2.0 for all four slots. Slots 1 and 2 are x16 slots, and slots 3 and 4 are x4 slots. As with the Mac Pro (Early 2008), placing a revision 1 card in a revision 2.0 slot works and results in a revision 1 link.
The Expansion Slot Utility is not required for these configurations, since the number of lanes for each slot are permanently set."
- - - - -
Having said that, the drive bays all run at SATA II, but the PCI slots are not related in this way, but rather by whether they are PCI Express revision 1.0 or 2.0.
PCI Express Info
Per lane (x1)
PCI Express 1.0 = 250MB/second
PCI Express 2.0 = 500MB/second
Hope that helps.
Wait a second... So you're telling me anything that happens in the sky is legal, and there's a giant crime-blimp flying around this place? I don't know how I missed that.
|Thread Tools||Search this Thread|
|thread||Thread Starter||Forum||Replies||Last Post|
|Advice on upgrade install for mac pro 2009||TVM70||Mac Pro||1||Feb 24, 2014 12:16 AM|
|Macbook Pro Upgrade Advice||ladylogic||MacBook Pro||1||Nov 8, 2013 11:16 AM|
|Need advice on Mac Pro processor upgrade||postbeck||Mac Pro||18||Nov 1, 2013 06:35 PM|
|Hard Drive Failure = Excuse to upgrade 2009 Mac Pro. Advice!||DustinB85||Mac Pro||4||Dec 20, 2012 01:26 AM|
|Need to upgrade from MacBook Pro for photo editing. Need advice.||Ramtink||MacBook Pro||6||Nov 20, 2012 04:05 PM|
All times are GMT -5. The time now is 04:42 AM.