|Dec 13, 2012, 12:31 AM||#1|
Airport Express. Multiple Connections Solution
Just read this article 'Matrox Launches DS1'
I have an Airport Express, and my USB3 harddrive cannot connect to the express due to 'too low power supply' of the Express.
Using the DS1, which has a power input, could one connect lets say.. 2 x USB2 Harddrives and 1 x USB3 harddrive to the Express via a USB to Thunderbolt cable adaptor?
|Dec 13, 2012, 12:38 AM||#3|
That's a lot of power you are asking from the device....We don;t have the full specs yet, but my gut instinct says no. A buddy has a brand new 21.5" iMac and he purchased a USB 3 powered hub for use with it.
I helped him with the setup as he's new to Mac, but when I plugged in my Apple external superdrive, the yellow "Insufficient Power" message appeared, and that was from a powered USB hub...It couldn't even run the motor in a superdrive. I think you'd be way better off sourcing powered devices....A policy I have always adopted...Powered caddy's are cheap enough so you don't have to spend megabucks to get reliable performance. I doubt the Matrox would provide enough power, but I could be wrong. My philosophy has always been to avoid drawing power from USB ports on my Mac's...I does put extra load on the PSU. The only device plugged into a USB port apart from y powered hub is the KB.
..That's All Folks
|airport, ds1, express, hard drive, multiple|
|Thread Tools||Search this Thread|
All times are GMT -5. The time now is 12:01 PM.