I have fusion 3.1 installed. Windows7 x64
The programs i need Windows for, connect to a phone system via ports in teh 8000's.
I have never been able to get these to fully work. It seemed that something was always blocking. Windows firewall off. No MAC firewall.
So i installed BootCamp. Loaded everything and tested on the Bootcamp partition, all works well.
Went into MAC, and found I could use VMware on the Bootcamp image....
Loaded vmware drivers, rebooted and all. Accessed the Bootcamp image from VMWare, and same problem, something blocking same ports...
If i go directly to the Bootcamp drive and boot, all works well. If I use vmware, no worky...
Does Vmware block anything? I dont see anything that would indicate that...
Any help would be greatly appreciated.
The programs i need Windows for, connect to a phone system via ports in teh 8000's.
I have never been able to get these to fully work. It seemed that something was always blocking. Windows firewall off. No MAC firewall.
So i installed BootCamp. Loaded everything and tested on the Bootcamp partition, all works well.
Went into MAC, and found I could use VMware on the Bootcamp image....
Loaded vmware drivers, rebooted and all. Accessed the Bootcamp image from VMWare, and same problem, something blocking same ports...
If i go directly to the Bootcamp drive and boot, all works well. If I use vmware, no worky...
Does Vmware block anything? I dont see anything that would indicate that...
Any help would be greatly appreciated.