Toggle sidebar Toggle sidebar
Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.

Fusion - fixed IP address connection with hardware?

J

jeffy.dee-lux

macrumors 6502a
Original poster
Hi there,
I'm doing some work with a National Instruments embedded controller, and it's programmed using LabView. When I'm in Windows, to communicate with the thing I just connect it with a cross-over ethernet cable, and set the computer to a fixed-IP address.

I was struggling to figure out exactly how I could set this up through Fusion, rather than booting up in Windows through bootcamp. I was assuming I would use Bridged mode and then set it to Fixed IP address in Windows. Would I also need to set my Mac side to fixed IP address??

Thanks for your help.
 
You must log in or register to reply here.
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.
Top Bottom
Back