When I try to make my airport extreme into share my a single ip address it says I have two problems: DHCP Beginning & Ending Address. I have no idea what to do to make this work so I can get vuze to upload. Thanks!
Got a tip for us?
Let us know
Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.
DHCP Beginning & Ending Address Problem In Airport Extreme
- Thread starter havenhamilton
- Start date
- Sort by reaction score
Well.. did you go to airport utility and see what the DHCP beginning and ending addresses are set to?
the thing is it's set to bridge mode which i'm trying to change, when i change it to 'share a public ip" dhcp option comes up. what should i put as the beginning and ending address?
If it's just one modem connected to one router on your whole network, then you could set the beginning to 192.168.1.2 and ending to 192.168.1.200
bmorris
macrumors 6502
I Think I Found A Fix!!!
I went to Manual Setup > Internet > Share IP > DHCP
For Beginning Address I changed 192.168 to 10.0 followed by . 1 . 1
For Ending Address I put 10.0.1.200
I went to Update and it said Double NAT error, I said Ignore, and it seemed to resolve itself. It's working fine now.
I went to Manual Setup > Internet > Share IP > DHCP
For Beginning Address I changed 192.168 to 10.0 followed by . 1 . 1
For Ending Address I put 10.0.1.200
I went to Update and it said Double NAT error, I said Ignore, and it seemed to resolve itself. It's working fine now.