Toggle sidebar Toggle sidebar
Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.

BSE, Bodyguardz, etc - film thickness

C

chefwong

macrumors 6502
Original poster
It's been awhile since I've messed with film for a electrical device....

but totally familiar with PPF film, ventureshield, 3m etc, etc.

Between the BSE or Bodyguardz, which film is more *thinner*.
Film does come in various thickness, orange peel, clearcoat, etc...
 
I actually contacted BSE about this just out of curiosity and its .2mm
I bought the BSE and was VERY satisfied with it...
A tip when applying the back: do the "flat" part (the largest surface) first and squeegee out all the water and air, wait 20 minutes, and then put the sides on. They stick well if they are completely dry, and since they are so close to the surface there is little resistance to rubbing out any bubbles that may form due to lack of water.
 
You must log in or register to reply here.
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.
Top Bottom
Back