AirPort configuration help needed

Discussion in 'Macintosh Computers' started by rendezvouscp, Jan 19, 2004.

  1. rendezvouscp macrumors 68000

    Joined:
    Aug 20, 2003
    Location:
    Long Beach, California
    #1
    Hello! I just set up my AirPort Extreme Base Station, and while the Base Station pretty much connected itself, I want to configure its settings. So I used the Admin Utility, but whenever I put in the password public (or any password, since I did not set up a password) it responds that "The AirPort Admin Utility was unable to read the configuration of the selected base station. An error occured while reading the configuration." Does anyone have any suggestions?
    Thanks in advance,
    –Chase
     
  2. rendezvouscp thread starter macrumors 68000

    Joined:
    Aug 20, 2003
    Location:
    Long Beach, California
    #3
    i got it to work after hard resetting, then restarting, reconnecting with internet connect, and then configuring again. thank you
    –Chase
    P. S. I don't think this is a very reliable solution, it took me a couple of resets after that once i could configure it once
     

Share This Page