eMac Power Switch..

Discussion in 'PowerPC Macs' started by 76ShovelHead, Jan 21, 2011.

  1. macrumors 6502

    Joined:
    May 30, 2010
    Messages:
    484
    Location:
    Connecticut
    #1
    Well i was inside my eMac yesterday, and while i just connected the power switch to the cable i remembered i had to go back in, so almost instantaneously i ripped the cover off the computer and then i remember i should have disconnected it... :( well my luck is that only one of the prongs on the switch on the case is missing. Will that hinder it in any way? Because 3 of the 4 are still in tact? how would i go about putting a new one in? Thanks..
     
  2. macrumors 68040

    666sheep

    Joined:
    Dec 7, 2009
    Messages:
    3,247
    Location:
    Poland
    #2
    Second one counting from the right? :D Don't worry, it wasn't there from the start. Look at power switch plug: "hole" for this prong is a little smaller than other ones. You didn't break anything :)
     
  3. macrumors 6502

    Joined:
    May 30, 2010
    Messages:
    484
    Location:
    Connecticut
    #3
    Haha yea, i't gave me some problems turning on today, which made me worry so i took it apart and then i saw, wait theres no wire on the one i thought i broke lol and this just confirmed it, thanks.
     

Share This Page