firmware problem?

Discussion in 'Mac Pro' started by paul9166, Jan 28, 2006.

  1. macrumors newbie

    Joined:
    Jan 5, 2006
    #1
    Does any body know how to revive a imac g3? After trying to load macos 10.2 and getting the dialogue box about incorrect firmware, the machine will only spin for about 5secs and then die. I've tried resetting the p-ram, new battery, pressing the programmers button on startup and spent hours scannning the net for solutions. I believe that there is nothing physically wrong with the machine and that somehow the software/firmware has become scrambled. I have also tried an external monitor and disconnecting the internal monitor with no progress. I have heard that you can remove the hard drive and link it to another computer to revive it, but is it a hard drive problem or main board problem? Can fire wire be used to network it to another machine?
     
  2. Moderator emeritus

    mad jew

    Joined:
    Apr 3, 2004
    Location:
    Adelaide, Australia
  3. thread starter macrumors newbie

    Joined:
    Jan 5, 2006
    #3
    Unfortunately not. But the a dialogue came up asking to continue or cancel. When I cancelled the remainder of the installation it was too late. The machine is a dv400 10gb slot loading imac g3 grape, bought in December of 1999 and had no known failings until that point.
     

Share This Page