Handbrake CLI - --start-at and --stop-at

Discussion in 'Apple TV and Home Theater' started by theSeb, Dec 9, 2011.

  1. macrumors 604

    theSeb

    Joined:
    Aug 10, 2010
    Location:
    Poole, England
    #1
    Hi,

    I cannot figure out how to use these parameters properly. Whatever values I put in there seem to be ignored and handbrake tries to encode the entire clip.

    Any ideas on how I should be using these two and what the value format is?

    ./HandBrakeCLI -i ~/Desktop/Test/work3 -o "stuff.m4v" --stop-at=10 --preset="High Profile"
     
  2. macrumors 6502a

    Joined:
    Dec 30, 2008
    Location:
    Nottingham, UK
    #2
    The correct format is:-

    For time in seconds ie start at 150 seconds and end at 300 seconds:-
    Code:
    --start-at duration:150 --stop-at duration:300
    Or for frames ie start at frame 2000 and end at frame 5000:-
    Code:
    --start-at frame:2000 --stop-at frame:5000
     
  3. thread starter macrumors 604

    theSeb

    Joined:
    Aug 10, 2010
    Location:
    Poole, England
    #3
    Thanks mate
     

Share This Page