InvisibleShield

Discussion in 'iPhone Accessories' started by DopestGingah, Aug 4, 2007.

  1. macrumors regular

    Joined:
    Apr 24, 2007
    #1
  2. macrumors 6502a

    Joined:
    Aug 30, 2006
    #2
    Have you tried looking at this? http://youtube.com/watch?v=MmpFOUZoUX0

    He only does the front side, but it should be about the same all around. Just remember not too be that generous with the application fluid especially around the speaker/mic holes.
     
  3. macrumors 65816

    mrat93

    Joined:
    Dec 30, 2006
    #3
    I assume your problem is that you can't keep the sides down without having them come back up. I just left the back to adhere first. Then I sprayed the left and right sides and held them on the iPhone for a minute. Then the edges of the sides had space, so I just sprayed it and held it again until it was good. Pretty much the same thing with the top, but it was more of a hassle with the button and headphone jack. The bottom was less of a hassle. Hope it helps.
     
  4. thread starter macrumors regular

    Joined:
    Apr 24, 2007
    #4
    Yeah it is basically just a hassle putting it on the back. One of my biggest problems is that my fingers get fingerprints on the adhesive and then it will not stick!! How did you overcome this? Just keep your fingers off it?
     
  5. macrumors 6502

    Joined:
    Aug 8, 2006
  6. thread starter macrumors regular

    Joined:
    Apr 24, 2007
    #6
    With just water or the solution stuff? Is the solution stuff just water?
     
  7. macrumors 6502a

    Joined:
    Aug 30, 2006
    #7
    The solution stuff.

    I think it's just slightly soapy water. At least this is what the iLounge Review says.
     

Share This Page