Lightscribe Lite-On LH-20A1H-185 is a tight fit

Discussion in 'Mac Pro' started by Tibbar, Jan 30, 2007.

  1. Tibbar macrumors member

    Joined:
    Jan 28, 2007
    #1
    After removing the front plate, the sliding drawer of the Lite-On DVD-RW drive comes out too low and scrapes the bottom of the mac pro's drive opening, getting stuck about a quarter of its length. I tried adjusting to no avail. So I had to switch the new drive up to the higher bay in order for it to open reasonably well.

    I picked this drive because of the recommendation given on the Accelerate Your Macintosh! web page. Just letting everyone know that it takes some fiddling.
     
  2. jeremy.king macrumors 603

    jeremy.king

    Joined:
    Jul 23, 2002
    Location:
    Fuquay Varina, NC
    #2
    Is the Mac Pro anything like the MDDs? I know when I had my MDD, I had to take the front bezel off the drive to make it work properly with the spring loaded doors.
     
  3. OllyW Moderator

    OllyW

    Staff Member

    Joined:
    Oct 11, 2005
    Location:
    The Black Country, England
    #3
    Can you remove the front panel off the tray?

    I fitted a Pioneer drive to my old MDD G4 PM and had to take the front off the tray to prevent it fouling as it ejected.
     
  4. Tibbar thread starter macrumors member

    Joined:
    Jan 28, 2007
    #4
    I should clarify: I removed the drawer front panel beforehand. The scraping occured along the bottom of the drawer itself.
     

Share This Page