Problem with iSync 1.1 and a Palm

Discussion in 'Mac Help/Tips' started by shakespeare, Jun 3, 2003.

  1. shakespeare macrumors 6502

    Joined:
    Apr 29, 2002
    Location:
    Portland, Maine
    #1
    Since I upgraded iSync to 1.1, I can't get it to recognise my Palm Tungsten T. It removed it from the list of devices, and when I scan for new devices, it doesn't show up. I have installed the new iSync conduit, too, and even rebooted, but to no avail. Can someone help me?
     
  2. mnkeybsness macrumors 68030

    mnkeybsness

    Joined:
    Jun 25, 2001
    Location:
    Moneyapolis, Minnesota
    #2
    it's not supported anymore?

    well i still have iSync 1.0. if that worked for you, IM me or PM me and i can send it over for ya.
     
  3. Sol macrumors 68000

    Sol

    Joined:
    Jan 14, 2003
    Location:
    Australia
    #3
    Un-plug then re-plug the cable

    That sounds odd. I use an m100 and after installing iSync 1.1 as well as Palm Cond. 1.1 the syncing worked the same as before. I do not know how the Tungsten connects to your Mac but on my system I have to unplug the USB connection and re-plug it before I press the Sync button on my Palm's cradle. Perhaps you can try the same on your system.
     
  4. shakespeare thread starter macrumors 6502

    Joined:
    Apr 29, 2002
    Location:
    Portland, Maine
    #4
    Well, the only way I could make it work was to delete everything connected with Palm or iSync, and then reinstall it all. It kind of sucked, but it was over in a few minutes, and there's no trouble now.

    By the way, I sync over Bluetooth.
     

Share This Page