Ugg!!

Discussion in 'Macintosh Computers' started by buzzfgo, Sep 15, 2004.

  1. buzzfgo macrumors member

    buzzfgo

    Joined:
    Sep 9, 2004
    Location:
    Up State NY
    #1
    I replaced the HD in my new emac. All went well until I put the case back on. I ripped the power cable to the button. Right where it connects. Can this be hard wired? Or should I just take it in to be fixed?
     
  2. Rod Rod macrumors 68020

    Rod Rod

    Joined:
    Sep 21, 2003
    Location:
    Las Vegas, NV
    #2
    I took apart a 700MHz eMac two or three times and luckily I never broke the power button wire.

    If your eMac is anything like the one I used to have, maybe you could reconnect the wire that came loose. Good luck and hopefully you'll get to repair it. The risk you run in taking it in is they blacklist your eMac with a voided warranty.
     
  3. buzzfgo thread starter macrumors member

    buzzfgo

    Joined:
    Sep 9, 2004
    Location:
    Up State NY
    #3
    ok, off to the shop I go. It looks like its a pretty easy fix. A little tape backed connector then the plug and go back in.
     
  4. buzzfgo thread starter macrumors member

    buzzfgo

    Joined:
    Sep 9, 2004
    Location:
    Up State NY
    #4
    I just got my emac back and was told by the tech that he hooked me up and it was all covered. I flipped him $20 and a thanks. Apple Rocks!!!
     

Share This Page