Failed RAM Upgrade in G4

Discussion in 'Macintosh Computers' started by abcd1234, May 5, 2004.

  1. abcd1234 macrumors newbie

    May 5, 2004
    I recently tried to upgrade a G4 running Mac OS X 10.2 from 64MB of RAM to 128MB. The SIMM I put into the G4 came from a Umax machine. It fit the slot okay, but now when I power up the computer it will not boot. Even after restoring the original SIMM alone it will not work. The power supply fan starts spinning and then shuts off. I realize I probably inserted an incorrect RAM type. Is there any way to repair this problem or did it do something permanent to the board?
  2. krisjon macrumors regular

    Feb 29, 2004
    San Diego, CA
    If it was old RAM out of a Umax, then aside from it being the wrong kind of memory, it also might not have been the right voltage rated memory either. I used to have an old mac clone and I think a lot of those machines used 3.3 voltage RAM chips. Either way, it doesn't sound good. Don't mean to beat you up, but what were you thinking trying to put such old RAM in a newer machine without checking specs?
  3. FuzzyBallz macrumors 6502a


    May 2, 2003
    Home of Al-Qaida
    Man, you better cross your fingers and hope you didn't fried the RAM sockets and channels. I don't get how you can just jam anything in there w/o checking 1st. This is like adding diesel to your unlead gasoline engine because you found some in the garage and thought it's free.
  4. Sun Baked macrumors G5

    Sun Baked

    May 19, 2002
    Let's see you stuffed 168-pin 5 volt EDO or fast-page DRAM, into a slot that needs 3.3v 168-pin PC100 or PC133 SDRAM because it just happened to fit into the slot. :rolleyes:

    Could have shorted out the motherboard and/or the CPU.

    Now that's what I call an intelligent means of trying to save $20.

Share This Page