InvisibleSHIELD and Apple logo on front of my Air

Discussion in 'MacBook Air' started by petalino, Jan 7, 2011.

  1. petalino macrumors regular

    Nov 21, 2010
    I just installed Zagg InvisibleShield on the back of my 11" Air.

    While it does not look as great as the pure aluminum surface, it does its job of protection against scratches.

    Today I should be ready to cover the top part with the plastic Apple logo in it.

    I am afraid that I might push the wettting solution into the Air itself, since there must be a small gap between the alu chassis and the logo itself. How do you guys deal with this?

    Also because of the tiny gap, will air not be trapped there? Does it not look rather cheap?
  2. iCheddar macrumors 6502a


    Apr 30, 2007
    South Dakota
    As long as you don't put a gallon of liquid on the top of the case, you should be just fine.

    I've done skin installs on plenty of devices with no problems.

    You are correct to observe that air might get trapped in the gap, what you need to do is thoroughly go over the top of the case with your squeegee to eliminate air bubbles. If you are through, you should only have a couple really tiny bubbles left in the gap - they will go away as the skin and the adhesive cures.
  3. ejisfun macrumors regular

    Jan 7, 2011
    I had no problem with any water going into my air.

    To get the air bubbles out, I found that a credit card was too rigid to work around the curves of the apple. So, I worked out a technique of pressing with my finger to get the air out of the apple, then immediately catching it with a credit card before the air went back into the apple.
  4. BeyondtheTech macrumors 68020


    Jun 20, 2007
  5. JesseW6889, Jan 7, 2011
    Last edited by a moderator: Jan 7, 2011

    JesseW6889 macrumors 6502

    Dec 12, 2010
    I disagree... I installed the invisible shield on my 13" a month ago and had no issues with trapped air on the apple logo, I also got a fair amount of water 'in' around the edges ect, but I blew it out with compressed air and let it sit for a little while.


    You can submerge this thing in water (don't!) and it doesn't 'hurt' the components, its the impurities in the water that allow the electricity to 'travel' between circuits its not supposed to travel between.

    The problem I DID have with this invisible shield, was TINY specks of 'whatever' and hair, etc falling onto the surface while peeling it off the backing, ALSO, be very careful to wet the adhesive side down as you're peeling it off, as if adhesive meets adhesive (which is likely while peeling off such a large piece) you're not going to like the force needed to separate the two :/

    Edit: The biggest problem since using the invisible shield is on the wrist pad... the 'lip' that goes into the keyboard divot adds height to the ridge underneath the keyboard, and over time, your hands will get the ridge dirty, and transfer the dirt onto the screen when the laptop is closed. I wash my hands before using, or I put a cloth in when the lid is shut, good luck!

Share This Page