Pwnage Tool 2.0.2 + iPhone 3G + Firmware 2.0.1 = No Service? [RESOLVED]

Discussion in 'Jailbreaks and iOS Hacks' started by FreakinSyco, Aug 9, 2008.

  1. FreakinSyco macrumors regular

    FreakinSyco

    Joined:
    May 3, 2007
    #1
    Perhaps I did something incorrectly?

    The steps I followed:

    I hooked the 3G up to to my mac
    iTunes said there was an update
    I downloaded it ONLY (it goes to library/iTunes/iPhone Software Updates)
    Opened Pwnage 2.0.2
    Set to Expert mode
    Click iPhone 3G
    Chose the ipsw
    Turned off the custom logos, left everything else default
    Built the firmware
    Did the DFU dance
    Option clicked the restore button in iTunes
    Chose the new ipsw
    Loaded it up
    Loaded the backed up settings from the iTunes

    So now I have my 3G which appears to be jailbroken and everything is working fine except I have no service? This was previously a perfectly legit ATT iPhone.

    BTW I've preformed this exact process twice and ended up with the same results. I'll attempt to load the stock 2.0.1 firmware tomorrow unless someone can point out what I've done wrong. I'm not too worried since everything other than service is working fine.
     
  2. dc0511 macrumors member

    Joined:
    Nov 3, 2006
    #2
    When creating the custom ipsw you have to uncheck activate the phone under the general tab in expert mode. Should be fine after that.
     
  3. benflick macrumors 68020

    benflick

    Joined:
    Jul 11, 2008
    Location:
    Cincinnati, Ohio
    #3
    yeah, try that
     
  4. FreakinSyco thread starter macrumors regular

    FreakinSyco

    Joined:
    May 3, 2007
  5. FreakinSyco thread starter macrumors regular

    FreakinSyco

    Joined:
    May 3, 2007

Share This Page