Symptoms of death - I need a diagnosis

Discussion in 'MacBook Air' started by Blackberryroid, Dec 24, 2012.

  1. Blackberryroid macrumors 6502a


    Aug 8, 2012
    My computer was running normally. Completely fine. It was treated normally*. I was using it for an hour then it flickered. The screen froze at one point, but the system was functional. I had to do a hard shutdown. I'm afraid to turn it on at this moment because I don't know what's wrong with it yet.

    *Here's how I treated it:
    • Three drops. Minor drops. Not screen cracking type of drop. Happened months ago
    • "Water Spillage". I wiped my keyboard using a cloth filled with 70% solution Alcohol, but the keyboard was wet. I wiped it until it was dry. Happened 2 hours before the flickering incident.

    Could it be a hardware problem (GPU/Logic Board)? Or a software one (EFI Software Update/Bugs)? When I booted up to Windows 8, the screen still flickers.

    Model: MacBook Air Mid-2012, i7, 8 GB RAM
  2. vampireszombies macrumors 6502

    May 20, 2011
    I don't think normal applies to 3 drops and a spill.
    If the problem occurred after the spill, it was obviously the spill that caused it. Instead of immediately soaking up the water you drenched it with more liquids (wet wipe).

    Edit: the "spill" was the wet wipe?
  3. barkmonster, Dec 24, 2012
    Last edited: Dec 24, 2012

    barkmonster macrumors 68020


    Dec 3, 2001
    You've caused water damage then made it worse by using even more liquid and dropped it numerous times.

    Not looking after ANY model of laptop is going to cause problems and they're problems you unfortunately can't blame anyone else for or likely resolve with the warranty because they're avoidable problems caused by your own clumsyness and the moisture sensors will show the cause isn't a hardware defect.
  4. blesscheese macrumors 6502a


    Apr 3, 2010
    Central CA
    If any water gets into your MacBook, or you suspect any water has gotten into your MacBook, the steps are to:
    a. immediately shut down, and then
    b. remove all power
    c. see if you can get water out.

    To get the water out, I would hold upside down and dry with absorbant cloth to get out as much as possible. To get out any remaining moisture, I would also highly recommend the "sticking in rice" trick for *several days*. This will remove any last vestiges of moisture.

    If you have water in your laptop, and you are running it, it is likely that it may short out, in which case, I would be afraid you have toasted the logic board.

    Not to be too anal about these things, but if I drink around my computer, I try to have a keyboard protector on.

Share This Page