PDA

View Full Version : Speaker connect for Ibook g3 700MHZ




yoshiii
Mar 21, 2006, 05:14 AM
Hello while installing the harddrive for a Ibook G3 700MHZ I accidently severed the small solder connection to the speaker wire connector. Can this be fixed by resoldering it or should I take it to a Apple store to have them fix it? If so how much does anyone think it will cost? Would Other World Computing be cheaper?

Help



munkees
Mar 21, 2006, 05:28 AM
Hello while installing the harddrive for a Ibook G3 700MHZ I accidently severed the small solder connection to the speaker wire connector. Can this be fixed by resoldering it or should I take it to a Apple store to have them fix it? If so how much does anyone think it will cost? Would Other World Computing be cheaper?

Help

if you feel skilled enough. Personally I would do it myself.

yoshiii
Mar 21, 2006, 05:39 AM
So it can be fixed back to the solder on the board than? I have a friend who says he can solder. Any advice on how to do it?

oldMac
Mar 21, 2006, 06:28 AM
Any advice on how to do it?

Very carefully. :)

yoshiii
Mar 21, 2006, 06:45 AM
ok

munkees
Mar 21, 2006, 10:33 AM
Depend on how big the solder pads are. if they are tiny then you need a fine tip soldering iron, to put a little bit more solder on, one the iron is heated, melt just a little on to the tip, then run the end of the wire in it.

place the tip of the soldering iron on the pad that need the cable connecting to melt the solder there, then place the wire on the melted soldier. life away the iron while holding the wire still and in place and with in 10 seconds should be connected