1. Welcome to the new MacRumors forums. See our announcement and read our FAQ

Quicksilver wont boot after cpu upgrade

Discussion in 'PowerPC Macs' started by mannyrm, Sep 10, 2009.

  1. macrumors member

    mannyrm

    #1
    Hi Guys,

    We have a quicksilver Single Core 867mhz, 1 gb of ram, 32 mb Vram running Leopard.

    Well we got a genuine 1.0 dual cpu, we removed carefully the 867mhz
    (of course I pulled the power cable and we grounded ourselves and the screwdrivers) and we then placed the thermal paste between the "new" cpu and it's heatsink, we left it for a min and then we fired up the quicksilver.

    Well all we get is a red light on the mobo, the power light comes on and goes off, the PS runs and the CPU fan spins, but no HDD activity.

    We decided to hit the cuda switch, nothing. Then we dremove the power cable and battery replaced it with a new battery and hit the power...same thing, We stripped the unit down.....same thing.

    So we placed the old cpu back and guess....same thing.

    I at my wit's end. Any suggestions?


    Thx
     
  2. macrumors 65816

    zmttoxics

    #2
    Sounds like you toasted it. Try repositioning the ram and resetting the nvram again.
     
  3. macrumors 65816

    macgeek18

    #3
    Sounds bad,I'm sorry that sucks.
     
  4. macrumors 601

    UltraNEO*

    #4
    Want some advice?
    Leave open heart surgery to experts. It's a lot less heartache. ;)
     

Share This Page