RAM worked in G4 but not eMac

[thereisnoneed]

I just upgraded my system so I too a 512 stick of ram out of my old G4 to put in my brothers eMac. The memory worked fine in my G4(AGP graphics) but the eMac 1ghz does not seem to see it.

Do these two machines not take the same type of memory?

[blue&whiteman]

I just upgraded my system so I too a 512 stick of ram out of my old G4 to put in my brothers eMac. The memory worked fine in my G4(AGP graphics) but the eMac 1ghz does not seem to see it.

Do these two machines not take the same type of memory?

I think what the emac takes is closer to powerbook/ibook ram. not 100% sure though.

[MontgomeryBurns]

They're both pc133 3.3v unbuffered 8-byte non-parity 168 pin sdram.

User exists.

[Sun Baked]

They're both pc133 3.3v unbuffered 8-byte non-parity 168 pin sdram.

User exists.The early G4 PowerMacs used PC100, with tight tolerances which quite a bit of PC memory didn't pass after firmware/OS updates.

So Apple changed the 100MHz bus machines to requiring PC133 memory -- so there may be PC100 in some of the 100MHz FSB machines.

[flyfish29]

I just upgraded my system so I too a 512 stick of ram out of my old G4 to put in my brothers eMac. The memory worked fine in my G4(AGP graphics) but the eMac 1ghz does not seem to see it.

Do these two machines not take the same type of memory?

Did you try resetting the memory a couple of times to be sure that it was seated properly when installed?

You might check to be sure the memory didn't get zapped by reinstalling in your G4 just to be sure.

Look up on Crucial.com which type of memory each uses.