I bought this fancy Samsung ML-1630/xaa at the Apple store w/a Macbook, running Leopard 10.5.1 
Have it connected to an Airport Extreme Base Station (AEBS).
I could see the ML-1630 in AEBS printers area. And I was able to correctly add the printer via the printer add utility in Leopard, after downloading the right driver from Samsung website . I was then able to print quite successfully.
The next day I go to print and can't print to the Ml-1630/xaa attached to the AEBS. I check through the airport utility and it no longer sees the printer.
After further troubleshooting, I have determined that if it turn off printer and cut power to AEBS, wait 30 seconds. And then I turn on printer and then turn on AEBS, the Samsung printer is recognized again.
But the Samsung ML-1630 is only accessible for a maximum of two minutes, after which is is no longer seen by AEBS and I can't print.
If I repeat the power cycle dance it will work again for up to two minutes.
Any suggestions short of cycling the power constantly?
Have it connected to an Airport Extreme Base Station (AEBS).
I could see the ML-1630 in AEBS printers area. And I was able to correctly add the printer via the printer add utility in Leopard, after downloading the right driver from Samsung website . I was then able to print quite successfully.
The next day I go to print and can't print to the Ml-1630/xaa attached to the AEBS. I check through the airport utility and it no longer sees the printer.
After further troubleshooting, I have determined that if it turn off printer and cut power to AEBS, wait 30 seconds. And then I turn on printer and then turn on AEBS, the Samsung printer is recognized again.
But the Samsung ML-1630 is only accessible for a maximum of two minutes, after which is is no longer seen by AEBS and I can't print.
If I repeat the power cycle dance it will work again for up to two minutes.
Any suggestions short of cycling the power constantly?