Hi everyone,
I am upgrading my 21.5" 2011 iMac by adding an SSD. Using the OCS kit. Everything went fine except... I can't get the logic board to sit back in correctly. And I can't see whats stopping it. As best I can tell its there is nothing there stopping it from going in and dropping correctly. However it seems to be sitting the bottom of the tray but the board screws are about 2cm too high so its clearly not in properly, but there isn't anything stopping it. Though I have plenty of WINTEL hardware PC experience this is the first MAC I have ever touched on the hardware side. Wondered if I am missing something obvious as a novice.
Here is an image showing the issue on the bottom right of the logic board. Its sitting too high.
Thanks in advance!
I am upgrading my 21.5" 2011 iMac by adding an SSD. Using the OCS kit. Everything went fine except... I can't get the logic board to sit back in correctly. And I can't see whats stopping it. As best I can tell its there is nothing there stopping it from going in and dropping correctly. However it seems to be sitting the bottom of the tray but the board screws are about 2cm too high so its clearly not in properly, but there isn't anything stopping it. Though I have plenty of WINTEL hardware PC experience this is the first MAC I have ever touched on the hardware side. Wondered if I am missing something obvious as a novice.
Here is an image showing the issue on the bottom right of the logic board. Its sitting too high.
Thanks in advance!