I used the "Light" theme in my DVD project, the one where drop zones are like plasma TVs. I cut small clips to go into those drop zones, but it seems the these "TVs" crop a lot of pixels and just center of clips is shown.
I figured out how to solve it: I set the Scale parameter in FCP to 73%. Now my clips fit just right on the horizontal axis (Drop zones are 16:9, my video is 5:4 so some veritcal cropping... but its not a big issue)
But now, when I burned a test DVD-RW, I noticed that there are some artifacts, horizontal lines that go through lower middle part fn those small clips, looks as if the video was not scaled properly. Now I dont know how to solve this problem without scaling clips back to 100%, thus loosing a lot of information around the center of them...
Any help?
I figured out how to solve it: I set the Scale parameter in FCP to 73%. Now my clips fit just right on the horizontal axis (Drop zones are 16:9, my video is 5:4 so some veritcal cropping... but its not a big issue)
But now, when I burned a test DVD-RW, I noticed that there are some artifacts, horizontal lines that go through lower middle part fn those small clips, looks as if the video was not scaled properly. Now I dont know how to solve this problem without scaling clips back to 100%, thus loosing a lot of information around the center of them...
Any help?