I have 2 eMacs. One is 10.1 and the other is 10.2. Both of them have been on the internet in the past but I did not set it up.
I use an ethernet cable to share the internet between my laptop running windows 7 that has wireless with my desktop that runs XP and cannot have wireless. I was told I could run the internet basically the same way from my laptop to my eMac.
I set my laptop to internet sharing and connected it with my eMac.This is how I set up my eMac.
Location - Automatic
Source - Built-in Ethernet
Under the TCP/IP tab
Configure - Using DCHP
The IP Address, Subnet Mask and Routher info came up automatically when I connect the Ethernet cable.
I was told to hit apply now and that was all I had to do. I just had to go to my browser and bam! I could get on the net but everytime I try it says connot connect to server on one and on the other it says the same and then says no dial tone detected.
Help would be greatly appreciated!
I use an ethernet cable to share the internet between my laptop running windows 7 that has wireless with my desktop that runs XP and cannot have wireless. I was told I could run the internet basically the same way from my laptop to my eMac.
I set my laptop to internet sharing and connected it with my eMac.This is how I set up my eMac.
Location - Automatic
Source - Built-in Ethernet
Under the TCP/IP tab
Configure - Using DCHP
The IP Address, Subnet Mask and Routher info came up automatically when I connect the Ethernet cable.
I was told to hit apply now and that was all I had to do. I just had to go to my browser and bam! I could get on the net but everytime I try it says connot connect to server on one and on the other it says the same and then says no dial tone detected.
Help would be greatly appreciated!