I have a multi-AirPort Extreme setup at home, with one doing the routing the others just acting as WiFi bridges.
forums.macrumors.com
However, with regards to the IPv6 settings, I'm not sure if I've set it up correctly. I haven't had any problems but I just want to check to make sure. Here is the setting on the AE that is the main router (with IP address whited-out):
Here is the setting on the AE units that are acting as WiFi bridges:
Notice I've enabled IPv6 sharing for the router, but not on the bridges. Is this correct?
The settings for Configure IPv6 are Link-local only, Automatically, or Manually. I've chosen Automatically on all of the units.
The settings for IPv6 Mode are Native or Tunnel. I've chosen Native on all of the units.
Extreme overkill (AirPort mesh)
I've mentioned this before but now that I have an all-Extreme WiFi network, I thought I'd post an AirPort Utility screen grab. My final AirPort Express died, leaving a small gap in my network, but instead switching to a true third party mesh network I decided to add one more AirPort Extreme...
forums.macrumors.com
However, with regards to the IPv6 settings, I'm not sure if I've set it up correctly. I haven't had any problems but I just want to check to make sure. Here is the setting on the AE that is the main router (with IP address whited-out):
Here is the setting on the AE units that are acting as WiFi bridges:
Notice I've enabled IPv6 sharing for the router, but not on the bridges. Is this correct?
The settings for Configure IPv6 are Link-local only, Automatically, or Manually. I've chosen Automatically on all of the units.
The settings for IPv6 Mode are Native or Tunnel. I've chosen Native on all of the units.