I bought a Zalman VF1000 in an attempt to make my X1900 a little more discrete. (in a MacPro 1,1)
Two problems:
1 - the new fan fixing nuts going at the back of the card seem to be a bit too thick for the card to still fit in the MacPro.
2 - the fan power connetor is bigger than the one on the X1900 card. The manual says that it should connect to a mobo fan connector, but I could not find any available. The only one I saw is used for the case fan. Should I use a splitter?
Two problems:
1 - the new fan fixing nuts going at the back of the card seem to be a bit too thick for the card to still fit in the MacPro.
2 - the fan power connetor is bigger than the one on the X1900 card. The manual says that it should connect to a mobo fan connector, but I could not find any available. The only one I saw is used for the case fan. Should I use a splitter?