I am working on a mirror door G4 867 DP, has 768 megs of ram. Apparently no firmware update is needed.
Right now os 9 and os 10.2 are installed on the system drive, both of them boot fine.
I have the original 10.2 installation CDs and a 10.3.2 retail package.
If I just launch the installer in os 9, an error message says it needs to boot from the CD. But When booting from the CDs (10.2 or 10.3), it holds at the grey screen with the grey wheel spinning. and once it made it to a blue screen with a 'preparing installation volume' after 10 minutes, but saw no change afterwards.
Someone on another forum is telling me that I need to remove all 3rd party RAM and Cards which would be a huge headache as this computer is in a commercial studio. Any advice in dealing with the install CDs would be appreciated. i need to install 10.3.4 on another partition, not the existing system drive.
Thanks
Right now os 9 and os 10.2 are installed on the system drive, both of them boot fine.
I have the original 10.2 installation CDs and a 10.3.2 retail package.
If I just launch the installer in os 9, an error message says it needs to boot from the CD. But When booting from the CDs (10.2 or 10.3), it holds at the grey screen with the grey wheel spinning. and once it made it to a blue screen with a 'preparing installation volume' after 10 minutes, but saw no change afterwards.
Someone on another forum is telling me that I need to remove all 3rd party RAM and Cards which would be a huge headache as this computer is in a commercial studio. Any advice in dealing with the install CDs would be appreciated. i need to install 10.3.4 on another partition, not the existing system drive.
Thanks