iPad 2 wont work after digitizer replacement.

[greenstumps]

I broke my screen and so I had to replace it, however the Wifi Antenna was glued to the front and since it was all smashed and ripped, I had to replace that too. I'm not sure if any one can spot anything wrong? I did have to lift the logic board up slightly to get the Antenna in, the power button doesn't seem to do anything, it'll only display something when I plug it in to the mains and unplug it. I know the lock switch works because when I flick it and it's plugged in, it displays that battery symbol.

Image of what the screen is displaying:

http://s21.postimg.org/f5qmfaft1/ipad_2.jpg

(lots of finger prints due to the amount of glass I had to get off the display)

http://s15.postimg.org/f04vi03ex/ipad_2_inside.jpg

I dunno if I have to plug the digitizer in or it wont turn on properly? I just don't want to do that yet if possible.

Thank You.

 

[Gav2k]

Your battery needs a charge and you shouldn't be powered on till both the lcd and digitiser is plugged in

 

[greenstumps]

Your battery needs a charge and you shouldn't be powered on till both the lcd and digitiser is plugged in

It had 100% charge yesterday and I properly turned it off.

Flicking that lock switch turns the display on, but the power button doesn't and there is no symbol saying it's charging, just that battery with a few red lines.

Home button works.

 

[greenstumps]

http://s3.postimg.org/9v5ic23e9/powercable.jpg

I'm guessing that is the problem, no idea it was even there since it was behind some rubber.

Gonna be a whole lot of fun to replace by the looks of it.... I better find a guide.