Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.

0186279

Cancelled
Original poster
Nov 5, 2009
1,452
357
I just got a bumper and think its awesome but it seems jiggle around a bit. Like when I push the lock button I feel it slide down a bit. HARDLY noticeable but wondering if it can damage the phone in the long run? The last rubber incase I had on my 3Gs did this and would move around the dust particles leaving small scratches on the phone.

So does yours have any give?
 
I have this issue, and I'm only concerned because it's not that tight at the top, causing the entire top side of the bumper to push the lock button in :(
 
I had that problem when I first put it on. Then I noticed some spots were the rubber was still stuck on the phone, slightly folded under. Flicked those spots in place with a fingernail and all is good now.
 
I had that problem when I first put it on. Then I noticed some spots were the rubber was still stuck on the phone, slightly folded under. Flicked those spots in place with a fingernail and all is good now.

Ditto, same here.
 
I had that problem when I first put it on. Then I noticed some spots were the rubber was still stuck on the phone, slightly folded under. Flicked those spots in place with a fingernail and all is good now.

Same here. It was a little tricky. I used my finger to push the rubber out, and into its proper place.
 
I had that problem when I first put it on. Then I noticed some spots were the rubber was still stuck on the phone, slightly folded under. Flicked those spots in place with a fingernail and all is good now.

Same, and you have to really search for it at times. After that, the phone seems to flush the case pretty well. But still kinda loose at times.
 
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.