Hey all
Mac Pro 4.1. Trying to follow the minimum config testing from the Apple Tech manual.
The power light comes on, fans spin but no boot, no chime. The power button if pressed will put it sleep like normal and if pressed again the light goes back on steady. It sat for 3 months after working fine. Replaced the Battery as it was low.
On page 35 it says, with all drives, video ect removed and the processor cage installed, after pushing the power button, when you push the Diag Button you should get:
Expected behavior:
• PSU PWROK (green), 5V STBY (amber), EFI DONE (green), GPU OK (green) LEDs illuminated
• No startup tone
• Front and rear processor cage fans (and PCIe fan, if installed) should spin slowly
Does this make sense? I get no EFI light or GPU light. If I install the Video Card I get the GPU light.
If I put in 1 drive I get the EFI Done light.
Does the GPU OK light really come with no Video Installed?
Mac Pro 4.1. Trying to follow the minimum config testing from the Apple Tech manual.
The power light comes on, fans spin but no boot, no chime. The power button if pressed will put it sleep like normal and if pressed again the light goes back on steady. It sat for 3 months after working fine. Replaced the Battery as it was low.
On page 35 it says, with all drives, video ect removed and the processor cage installed, after pushing the power button, when you push the Diag Button you should get:
Expected behavior:
• PSU PWROK (green), 5V STBY (amber), EFI DONE (green), GPU OK (green) LEDs illuminated
• No startup tone
• Front and rear processor cage fans (and PCIe fan, if installed) should spin slowly
Does this make sense? I get no EFI light or GPU light. If I install the Video Card I get the GPU light.
If I put in 1 drive I get the EFI Done light.
Does the GPU OK light really come with no Video Installed?