Hey has anyone come up with a working solution that will allow protection of the Front and Rear Camera Cutouts in the OtterBox Defender for the iPhone 5??
This is actually a nice case but the fact that the Front and rear cutouts are completely exposed without any screen protection leaves a lot to be desired.
In my opinion OtterBox dropped the ball by leaving these areas unprotected and susceptible to dust, dirt, water, scratching , etc.
From looking at the inside of the case the built in screen protector is slightly recessed to create a flush finish with the interior of the top plastic housing. If you remove the Built in screen protector and go with a Spiegen Glass T there is going to be a slight gap around the plastic of the screen cutout where the "recessed" original screen protector was. How have you folks been able to negate this situation?
Anyone have any thoughts on this?
Thank you
Cam
This is actually a nice case but the fact that the Front and rear cutouts are completely exposed without any screen protection leaves a lot to be desired.
In my opinion OtterBox dropped the ball by leaving these areas unprotected and susceptible to dust, dirt, water, scratching , etc.
From looking at the inside of the case the built in screen protector is slightly recessed to create a flush finish with the interior of the top plastic housing. If you remove the Built in screen protector and go with a Spiegen Glass T there is going to be a slight gap around the plastic of the screen cutout where the "recessed" original screen protector was. How have you folks been able to negate this situation?
Anyone have any thoughts on this?
Thank you
Cam
Last edited:
