Running OSX 10.4 on a G4 Powerbook.
The lower third (roughly) of my screen is broken, and will not refresh. I suspect a broken wire somewhere, as if I physically twist the display to the right angle, it works again - but only in that position.
My question is this: is it possible to, within the software of OSX, set the resolution to use only part of my screen, leaving a black bar at the bottom?
The lower third (roughly) of my screen is broken, and will not refresh. I suspect a broken wire somewhere, as if I physically twist the display to the right angle, it works again - but only in that position.
My question is this: is it possible to, within the software of OSX, set the resolution to use only part of my screen, leaving a black bar at the bottom?