Power Supply screen protector problem...

[Brewerpaul]

OK, I took off the cheapie screen protector I had on my iPhone 4, got a Power Supply anti glare set from the Apple store and put it on. Went on easily and perfectly except for one area at the edge near one corner which isn't sticking. This is covered by the edge of my case, but I'd still like to get it to stick. Any ideas? I can't call PS until Monday, and then I'll be at work.

 

[vincenz]

Try blowing hot air from a hair dryer on the corner. It should soften up the protector a little and you can start holding it down. If it doesn't work, you'll need a replacement.

 

[Brewerpaul]

Didn't work I'll call PS tomorrow to see about a replacement. I have the second one I can install, but I think I should get a free replacement for the one that appears to be defective.