Hi,
I just got a new C2D 2.33 MBP and connected it to my 24" Dell. At first the monitor said that the signal was outside its range, then after I turned the monitor off and back on again the image shows up, but there is a lot of noise and lines running through the image. I know that is is not the graphics card on the MBP because it wors fine when I connect it to my froends 23" ACD. Does anyone else have any experience with this or thoughts on what the problem is?
I just got a new C2D 2.33 MBP and connected it to my 24" Dell. At first the monitor said that the signal was outside its range, then after I turned the monitor off and back on again the image shows up, but there is a lot of noise and lines running through the image. I know that is is not the graphics card on the MBP because it wors fine when I connect it to my froends 23" ACD. Does anyone else have any experience with this or thoughts on what the problem is?
