Hi!
I recently purchased an EZ Quest RAID Triple Interface HD Enclosure and I have encountered a problem with it.
I installed two HDs in the enclosure: one 320 Gig and one 160 Gig HDs. I intended to initialize these as separate hard drives. When the drives were initialized (with Disk Utility), they were identified as a RAID with 320 Gig capacity.
I removed the 160 Gig HD and replaced it with a 200 Gig one. When I viewed the drives with Disk Utility, it was identified as a RAID with 400 gig capacity.
When I attempt to unmount the RAID, I cannot do so -- it remains as a RAID.
I'm not sure what the problem is. Does anyone has any ideas?
Thanks!
I recently purchased an EZ Quest RAID Triple Interface HD Enclosure and I have encountered a problem with it.
I installed two HDs in the enclosure: one 320 Gig and one 160 Gig HDs. I intended to initialize these as separate hard drives. When the drives were initialized (with Disk Utility), they were identified as a RAID with 320 Gig capacity.
I removed the 160 Gig HD and replaced it with a 200 Gig one. When I viewed the drives with Disk Utility, it was identified as a RAID with 400 gig capacity.
When I attempt to unmount the RAID, I cannot do so -- it remains as a RAID.
I'm not sure what the problem is. Does anyone has any ideas?
Thanks!