Resolved Thermal Calibration freezing

[gavinstubbs09]

So after my fun adventures with my new 2.7GHz G5, I have done lots like rebuilding the LCS. The last thing I did was swap the two CPUs due to heat, and I went to go re-calibrate them with ASD 2.5.7 and the thing says it will take 10 to 20 minutes per processor to calibrate. I've sat here for 40 minutes ago and it's stuck on the same task since 40 minutes that is "Calibration starting on CPU0." With no updates this far into it. Anyone have an idea or two?

I also can't move the mouse cursor, and pressing a key on the keyboard like caps lock, does not light up.


Edit:
Fixed with using ASD 2.5.8

Took about an hour and a half, but all is good now. When opening a program the fans will jump up then back down.

 

[iamMacPerson]

So after my fun adventures with my new 2.7GHz G5, I have done lots like rebuilding the LCS. The last thing I did was swap the two CPUs due to heat, and I went to go re-calibrate them with ASD 2.5.7 and the thing says it will take 10 to 20 minutes per processor to calibrate. I've sat here for 40 minutes ago and it's stuck on the same task since 40 minutes that is "Calibration starting on CPU0." With no updates this far into it. Anyone have an idea or two?

I also can't move the mouse cursor, and pressing a key on the keyboard like caps lock, does not light up.

Do you happen to have a copy of 2.5.8? You might try that just be sure.

 

[gavinstubbs09]

I'll give that a shot, cross fingers that it'll work!