Become a MacRumors Supporter for $50/year with no ads, ability to filter front page stories, and private forums.

cmcconkey

macrumors 6502
Original poster
Nov 22, 2005
313
5
Rocky Face, GA
I have a total of 4 AEBS at work and I am looking to get a stable wireless network set up throughout the building but I am needing a little bit of help.

The building is two floors with a concrete floor separating them but other than that they are open spaces. We are already running a wired network for the desktops but I have a about 10 laptops that I need to have on the system with a stable connection throughout the building. The occupied top floor has very good coverage from the first AEBS that was set up but the bottom floor has a lot of dead spots. What I was thinking was that I would use the original AEBS and one other on the top floor and then the other two on the lower floor. My problem is that I am not quite sure on how to properly (also most efficiently) extend my wireless.

I am running static IPs on all of my desktops and running DHCP assigned addresses on the laptops, these addresses are pulled from a range of 20 that I have opened at the Cisco firewall.

How do I need to configure the other AEBS to get the best signal? What other information do you need to best advise me on this?
 
Register on MacRumors! This sidebar will go away, and you'll see fewer ads.