I received Ghost Armor screen protectant for front and back of Ipad 2 today. Highly recommend this product for protecting front and back of display. Has a great feel and protect 100%. I have used invisishield and cannot stand the tacky feel or look. Ghost Armor is the same protectant used for cars and planes to protect against rock chips. I even use it to protect my cars radio display in 2010 Camaro. Hides fine scratches and they back 100%. I should get commission : >).....
It came via Fedex. Order on Monday and arrived today.
Comes with front and back cover for Ipad 2, Install instructions and soft cloth. (Ipad 2 and Sonic drink the the upper right not included)
Instructions state to use warm soapy water and saturate shield prior to installing. I used a small spray bottle along with small tool provided in a past kit with cloth.
Make sure you clean the Ipad well with lint free cloth. Be sure all fine dust particles are off surface. Spray shield with a large amount of soapy water. I recommend till dripping off edges. With wet hands and saturated shield apply to back of ipad. Align shield in place and start smoothing out film from the middle out. Easy to do until all bubbles and sides are down. Very easy to work with. If you miss align pull up and apply once more. In fact I noticed a very small piece of hair underneath film on this install. I raised film, sprayed more solution, removed hair and re applied. Takes minutes. While posting this allowing back to dry and then will apply front. More pics to come, but install so far.
Sorry about grammer and spelling---Trying to type fast.
Front of Ipad film
In place and near speaker area
Seemless design. Fits well with these little tabs. Edges look more pronounced in photos, but fits very well near camera area
Edges still drying
Gives a Shine but hard to know in place
I will try to get some pics while installing on the front in a bit. Need to make sure drying well.
It came via Fedex. Order on Monday and arrived today.

Comes with front and back cover for Ipad 2, Install instructions and soft cloth. (Ipad 2 and Sonic drink the the upper right not included)

Instructions state to use warm soapy water and saturate shield prior to installing. I used a small spray bottle along with small tool provided in a past kit with cloth.
Make sure you clean the Ipad well with lint free cloth. Be sure all fine dust particles are off surface. Spray shield with a large amount of soapy water. I recommend till dripping off edges. With wet hands and saturated shield apply to back of ipad. Align shield in place and start smoothing out film from the middle out. Easy to do until all bubbles and sides are down. Very easy to work with. If you miss align pull up and apply once more. In fact I noticed a very small piece of hair underneath film on this install. I raised film, sprayed more solution, removed hair and re applied. Takes minutes. While posting this allowing back to dry and then will apply front. More pics to come, but install so far.
Sorry about grammer and spelling---Trying to type fast.

Front of Ipad film

In place and near speaker area

Seemless design. Fits well with these little tabs. Edges look more pronounced in photos, but fits very well near camera area

Edges still drying

Gives a Shine but hard to know in place



I will try to get some pics while installing on the front in a bit. Need to make sure drying well.