Hello, I have the following setup and have two questions: 3 Airport Express... -I've set one up as the main base station. -I've set another up as a relay station -I've setup the third as a remote station On the remote station, I am try to get it to distribute IP addresses so I can connect a NAS box to it (I need that to pickup an IP). However, after I select "distribute IP addresses" and the remote station restarts, it reverts back to being unchecked. I also have a question about what "Airpot Network Name" I should enter under each Airport Express unit. Currently they all have the same name. Would this cause any conflicts? Thanks a lot in advance.