Back replacement iPhone 3g

Discussion in 'iPhone Tips, Help and Troubleshooting' started by rewindurmind, Jan 4, 2011.

  1. rewindurmind macrumors newbie

    Joined:
    Jan 4, 2011
    #1
    After a painstaking few hours of putting my iPhone 3g back-together replacing the back, I switched it back on and the Home button doesn't work and I keep getting "no signal". I was having serious trouble getting the ribbon cable #3 back in.. in fact it took over half-an-hour. I'm just about to try again but wanted to know if there could be anything that I've missed which is causing this... also, the vibrator isn't working, but I think that the home button and signal issues are somehow related and this isn't.

    Any help is very much appreciated.

    Oh, and it wouldn't charge
     
  2. j3yq macrumors 6502

    j3yq

    Joined:
    Dec 16, 2007
    Location:
    Iowa
    #2
    I had the same issue back when I was tinkering with the 3G, it only seemed to happen when i powered the iPhone on before fully snapping the LCD back into the case.
     
  3. rewindurmind thread starter macrumors newbie

    Joined:
    Jan 4, 2011
    #3
    So it worked fine when you put it all together?
     

Share This Page